File and Data Management
R&S
®
SMW200A
684User Manual 1175.6632.02 ─ 30
Remote command:
*RCL on page 847
File Manager
Accesses the "File Manager" dialog, see Chapter 11.8, "Using the File Manager",
on page 690.
11.4.2 How to Save and Recall Instrument Settings
Instrument settings can be saved to a file and loaded again later, so that you can
repeat the tests with the same settings.
To access and recall instrument setups quickly
► Assign the appropriate action to the [USER] key.
See Chapter 12.3.4, "How to Assign Actions to the [USER] Key", on page 738.
To save and recall instrument settings
1. Select SAVE/RCL > "Operation Mode > Save".
2. Select "Save Immediate 1".
The instrument saves its settings in the intermediate memory 1. The filename and
the storage location cannot be changed.
3. Adapt the instrument settings as required. Select "Save Immediate 2"
4. To restore the settings, select the "Operation Mode > Recall"
5. Select "Recall Immediate 1"
The instrument is restored to the previous state.
6. Select "Recall Immediate 2" to switch to the settings stored in the second file.
To save complete instrument settings
1. Select SAVE/RCL > "Operation Mode > Save".
2. In the file selection dialog, select a filename and storage location for the settings
file.
3. Select "Save".
A file with the defined name and path and the extension *.savrcltxt is created.
To restore instrument's configuration
Save the configuration as described in "To save complete instrument settings"
on page 684.
1. To restore settings, select SAVE/RCL > "Operation Mode > Recall".
2. To retain the current frequency and level settings, enable "Save/Recall > Exclude
Frequency/Level"
Saving and Recalling Instrument Settings
To Next Page
Loading...