File and Data Management
R&S
®
SMW200A
688User Manual 1175.6632.02 ─ 30
Refer to the description of firmware options for the syntax of the corresponding SCPI
command:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:CATalog
[:SOURce]:CORRection:CSET:CATalog? on page 1119
To list files with user data:
[:SOURce<hw>]:BB:DM:DLISt:CATalog? on page 1012
[:SOURce<hw>]:BB:DM:CLISt:CATalog? on page 1012
Functions for handling of data lists
Provided are the following standard functions for file handling:
"Select"
Select and load the file.
Remote command:
complete[:SOURce<hw>]:BB:DM:DLISt:SELect on page 1013
Refer to the descriptions of the firmware options for the correct syntax of the corre-
sponding SCPI command:
[:SOURce<hw>]:BB:<Digital Standard>:...:DATA DLISt
[:SOURce<hw>]:BB:<Digital Standard>:...:DSELect
"New"
Creates file with the specified "Filename".
To confirm, select "OK"; use "Cancel" to undo the operation.
To edit the file content, select "File Select > Edit".
"Edit"
Accesses the "Data List Editor" and loads the selected file for editing
See Chapter 5.6.3.7, "Data List Editor", on page 279.
Functions for handling of control lists
Provided are the following standard functions for file handling:
"Select"
Select and load the file.
Remote command:
[:SOURce<hw>]:BB:DM:CLISt:SELect on page 1013
"New"
Creates file with the specified name. To edit the file content, select
"File Select > Edit".
"Edit"
Access the "Control List Editor" and loads the selected file for editing,
see Control and Marker Lists Editor.
Recent files
Displays the files last used.
File Manager
Accesses the "File Manager" dialog, see Chapter 11.8, "Using the File Manager",
on page 690.
11.5.2 How to Create and Access Data and Control Lists
The general principle for accessing files with user data is described in "To access a
loadable data list file" on page 686. Detailed and further information on how to create
Accessing Files with User Data
To Next Page
Loading...