Rohde & Schwarz R&S SMW200A - Removing File System Protection

File and Data Management
R&S
®
SMW200A
697User Manual 1175.6632.02 ─ 30
This section provides an introduction to the topic. For comprehensive information, refer
to the application note 1GP72: Connectivity of Rohde&Schwarz Signal Generators.
● Removing File System Protection.........................................................................697
● Accessing the File System of the R&S SMW via ftp............................................. 698
● Accessing the R&S SMW File System via SMB (Samba).....................................699
● Using a USB Storage Device for File Transfer......................................................701
● Using a File Server for Test Files Exchange......................................................... 701
11.9.1 Removing File System Protection
Before you try to access the file system via ftp, SMB (samba) or USB, fulfill the follow-
ing:
●
Disable write protection on the file system
●
Enable the corresponding service or interface
To enable write permission on the file system
1. Select "System Config > Setup > Security > Security > General"
2. Enable "Volatile Mode"
3. Enter the "Security Password".
The default password is 123456. For more information, see Chapter 12.6, "Using
the Security Settings", on page 752.
4. Select "System Config > Setup > Maintenance > Shut Down"
5. Select "Reboot".
The system reboots. The enabled settings are active.
To enable file transfer via ftp
1. Select "System Config > Setup > Security > Security > LAN Services".
2. Enable "LAN Interface"
3. Enable "FTP"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 12.6,
"Using the Security Settings", on page 752.
5. Select "Accept".
To enable file transfer via SMB (samba)
1. Select "System Config > Setup > Security > Security > LAN Services"
2. Enable "LAN Interface"
3. Enable "SMB (Samba)"
4. Enter the "Security Password".
How to Transfer Files from and to the Instrument