Rohde & Schwarz R&S SMW200A - Creating Screenshots of Current Settings; Hardcopy Settings

File and Data Management
R&S
®
SMW200A
702User Manual 1175.6632.02 ─ 30
To access the file server
1. On each R&S SMW, map the required directory of the file server to the instrument.
Perform the steps described in Chapter 11.8.4, "How to Map a Network Folder",
on page 694.
2. On each R&S SMW, use the same alias name for the directory of the file server,
i.e. enter the same "Local Folder" (in this example Setups).
On any of the R&S SMW, you access the file server directly from the "File Man-
ager" and under the same name, e.g. /shares/Setups.
An extra advantage in remote control is that the same application program would
control the instruments.
For example, use the remote control command MMEMory:CDIRectory
"/shares/Setups" to set the default directory for mass storage.
11.10 Creating Screenshots of Current Settings
The save/recall function enables you to save current settings in a file. To document the
most important settings for a performed signal generation, you can also save a hard-
copy of the current display.
● Hardcopy Settings.................................................................................................702
● How to Save a Hardcopy of the Display................................................................706
11.10.1 Hardcopy Settings
Access:
► Press the HCOPY key.
Creating Screenshots of Current Settings