Rohde & Schwarz R&S SMW200A - Page 716

General Instrument Functions
R&S
®
SMW200A
716User Manual 1175.6632.02 ─ 30
Also, the R&S SMW is equipped with two INST TRIG x connectors. The instrument
trigger setting influences all sweeps and is effective in the List mode.
See Chapter 8.7, "Varying the RF Signal in List or Sweep Mode", on page 491.
The Table 12-1 gives an overview of the signals that can be applied to and output at
the USER connector.
Table 12-1: Mapping control signals to the USER x connectors
Connector Direction Assigned Signal Remark
USER 1, 2,
3
Input "Global Trigger 1/2"
"Global Next Segment 1/2"
1
-
1)
Requires R&S SMW-B10
Output
"Baseband <BB> Marker 1/2/3"
2
"Always 0/1"
Standard baseband
2)
where:
●
<BB> = A/B/C/D
In "System Configuration > Baseband
Source > Separate"
●
<BB> is omitted
In "System Configuration > Baseband
Source > Coupled"
●
<BB> = 1/2/3/4
In "System Configuration > Baseband
Source > Coupled per Entity"
Wideband baseband
2)
where:
●
<BB> = A/B
In 2x1x1 configuration with "System
Configuration > Baseband Source >
Separate" and
<BB> = A in all other configuration
●
<BB> is omitted
In "System Configuration > Baseband
Source > Coupled"
●
<BB> = 1
In "System Configuration > Baseband
Source > Coupled per Entity"
USER4,5,6 Input "Global Trigger 1/2"
"Global Next Segment 1/2"
1
"Pulse In A/B"
3)
3)
In an instrument equipped with 1 RF
path, the name of the signal is "Pulse In"
Output
"Baseband <BB> Marker 1/2/3"
2
"Signal Valid A/B"
4)
"Signal Valid A/B Neg"
4)
"Pulse Out A/B"
4)
"Pulse Sync A/B"
4)
"Pulse Video A/B"
4)
"Always 0/1"
4)
In an instrument equipped with 1 RF
path, the names of the signals are "Signal
Valid", "Pulse Gen" and "Pulse Sync"
USER4,5 Output "REG Trigger A/B"
USER6 Input "Feedback"
read-only automatic setting
Output "Manual Trigger"
Configuring Local and Global Connectors