Rohde & Schwarz R&S SMW200A - Page 763

General Instrument Functions
R&S
®
SMW200A
763User Manual 1175.6632.02 ─ 30
2. Select "System Config > Setup > Security > Security > Password Management >
Security Password".
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
User Name
Indicates the user name used for access to the Linux operating system and valid for
VNC, FTP and SMB (Samba) access.
User Password
Access: select "System Config > Setup > Security > Security > Password Management
> User Password".
Allows you to change and confirm the user password.
Old Password ← User Password
Enters the current user password. The default password is "instrument".
Note: We recommend that you change the default password before connecting the
instrument to a network.
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
New Password ← User Password
Enters the new user password.
The security password can contain decimal characters only.
Confirm Password ← User Password
Confirms the new user password by repeating.
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
Using the Security Settings