General Instrument Functions
R&S
®
SMW200A
764User Manual 1175.6632.02 ─ 30
Change Password ← User Password
Changes the user password accordingly.
Security Password
Access: select "System Config > Setup > Security > Security > Password Management
> Security Password".
Enables you to change and confirm the security password.
Old Password ← Security Password
Enters the currently used security password. The default password is '123456'.
Note: We recommend that you change the default password before connecting the
instrument to a network.
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
The security password is required when changing the status of the USB and LAN inter-
face.
New Password ← Security Password
Enters the new security password.
The security password can contain decimal characters only.
Confirm Password ← Security Password
Confirms the new security password by repeating.
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
Change Password ← Security Password
Changes the password accordingly.
12.6.5 How to Prevent Unauthorized Access
The default computer name and user password are instrument. The user password is
the password required for VNC, FTP and SMB (samba) connections. If, for example,
the VNC service or FTP are enabled, anyone in the network who knows the computer
name and user password of the instrument can access it.
The default security password is 123456. The security password is required when
changing the status of the USB and LAN interface.
To prevent unauthorized access, use the following configurations exclusively or com-
plementary:
●
"Changing the default user password of the instrument" on page 765
●
"Changing the default security password" on page 765
●
"Disabling the LAN interface" on page 765
●
"Disabling LAN services" on page 765
Using the Security Settings
To Next Page
Loading...