Rohde & Schwarz R&S SMW200A - Page 766

General Instrument Functions
R&S
®
SMW200A
766User Manual 1175.6632.02 ─ 30
2. Select, for example, "FTP > Off" or "VNC > Off".
3. Enter the Security Password.
4. Select "Accept".
Activating SMB version 1.0/2.0 client and server
By default, support of SMB client and SMB server of the SMB protocol versions 1.0
and 2.0 is deactivated.
Activate support only, if needed:
1. Select "System Config > Setup > Security > Security > LAN Services > Samba Ser-
vices".
2. Select "SMB 1.0/2.0 Client > On" and "SMB 1.0/2.0 Server > On".
3. Enter the Security Password.
4. Select "Accept".
Disabling the frequency and level indication in the status bar
These settings are useful to prevent unauthorized personnel from reading the display,
when you remotely control the instrument from a different location.
1. Select "System Config > Setup > Security > General > Manual Operation".
2. Select "Annotation Frequency > Off" or "Annotation Amplitude > Off".
3. Enter the Security Password.
4. Select "Accept".
Deactivating the user interface
1. Select "System Config > Setup > Security > General > Manual Operation".
2. Select "User Interface > Disabled".
3. Enter the Security Password.
4. Select "Accept".
The screen shuts off and displays a padlock symbol instead.
There are further possible configurations. For details, see "User Interface"
on page 758.
Unlocking (reactivating) the user interface for manual operation
1. In manual operation:
Using the Security Settings