Getting Started
R&S
®
SMW200A
77User Manual 1175.6632.02 ─ 30
The instrument in this example is a R&S SMW equipped with two signal paths:
●
2 options standard baseband generator R&S SMW-B10 and one R&S SMW-B13T
●
2 options fading simulator R&S SMW-B14 and one option fading MIMO R&S SMW-
K74
●
Frequency options (e.g. R&S SMW-B1003/-B2003)
●
2 options R&S SMW-K55 EUTRA/LTE
To access the "System Configuration" function
1. Perform one of the following:
a) On the "Taskbar", select "System Config > System Configuration"
b) In the block diagram, select "Fading > MIMO > System Configuration"
c) In the block diagram, select "I/Q Stream Mapper" and select the "Fading/Base-
band Configuration" tab.
Trying Out the Instrument
To Next Page
Loading...