Getting Started
R&S
®
SMW200A
78User Manual 1175.6632.02 ─ 30
The "System Configuration > Fading/Baseband Configuration" dialog displays the
current signal routing. The instrument works in the default "Standard" mode.
1 2
Figure 3-17: System Configuration in the default Standard Mode
1 = Standard or advanced mode; the last is required for configuration of complex LxMxN MIMO scenar-
ios
2 = Simplified preview diagram with a description of the common application for the particular configura-
tion
2. Open "System Configuration > I/Q Stream Mapper" to obtain an overview of the
current distribution and mapping of the I/Q streams to the output connectors, see
also "To map the I/Q stream and define the output connector" on page 67.
3. Open "System Configuration > External RF and I/Q Instruments" to gain informa-
tion on the current setup.
The tab comprises the additional settings provided to simplify the configuration of
connected instruments, like configuring the connectors, establishing a connection
to the instruments, or controlling these instruments.
In this test setup, no further instruments are connected.
To enable a 2x2 MIMO configuration (1x2x2 "Fading and Baseband Configura-
tion")
1. In the "System Configuration > Fading/Baseband Configuration" dialog, select
"Mode > Advanced" and enable the following settings:
a) "Entities (Users, Cells) > 1", "Basebands (Tx Antennas) > 2", "Streams (Rx
Antennas) > 2"
b) Select "BB Source Config > Coupled Sources"
c) Observe the signal routing displayed on the preview diagram. Does it match
with the expected signal routing?
d) Select "Apply" to confirm the configuration.
Trying Out the Instrument
To Next Page
Loading...