Rohde & Schwarz R&S SMW200A - Page 80

Getting Started
R&S
®
SMW200A
80User Manual 1175.6632.02 ─ 30
In coupled baseband source mode, the R&S SMW takes over the baseband signal
configuration. The instrument adjusts the settings in the basebands automatically,
for example the mapping of the transmitting antennas to the basebands.
2. In the block diagram, select "Fading > On".
The default "Standard Delay" fading profile is applied.
3. On the "Status Bar", set the same frequency and level settings for both paths:
a) "A Freq = B Freq = 2.143 GHz"
b) "Lev (A) = Lev (B) = -20 dBm"
4. In the block diagram, select "RF A > On" and "RF B > On".
The R&S SMW generates a realistic EUTRA/LTE downlink signal with 10 MHz
channel bandwidth, though without any scheduled data.
To enable the generation of scheduled data, further configurations are required; these
configurations are, however, outside the scope of this description.
For further information, refer to the user manual "EUTRA/LTE Digital Standard for
R&S SMW".
Trying Out the Instrument