Network Operation and Remote Control
R&S
®
SMW200A
814User Manual 1175.6632.02 ─ 30
While remote control is active, the "Remote" icon in the status bar indicates that the
instrument is in remote control mode. Currently ongoing communication (data
transfer) is indicated by green colored arrows in the icon.
Also, the "Connections" softkey in the taskbar shows the currently established
remote connections.
Operating via the front and touch panel or via mouse and keyboard are locked,
allowing a remote control program to be performed without interruption. On the dis-
play, keys and entry fields are grayed out and cannot be activated or modified, but
you can still open dialogs, for example to verify settings.
5. To disable the access to the dialogs, use the command SYST:KLOC ON.
6. To prevent unintentional return to manual operation, use the command &LLO.
See also Chapter D.1.2, "LAN Interface Messages", on page 1315.
The instrument switches to "Remote LLO" state. The [SETUP] key is disabled.
7. To enable the [SETUP] key, use the command >R.
8. To return to manual operation, see Chapter 13.7.9, "How to Return to Manual
Operation", on page 819.
Tip: Switching from manual operation to remote control and vice versa does not
affect the other instrument settings.
Controlling the R&S
SMW Remotely
To Next Page
Loading...