Network Operation and Remote Control
R&S
®
SMW200A
830User Manual 1175.6632.02 ─ 30
Finding out a function in manual operation corresponding to a SCPI command
If you are searching for the associated function to a remote command in the manual
operation (GUI), proceed as follows:
1. Point of origin is the description of a remote control command in the user manual,
in the following example the "Trigger Mode" of the digital modulation dialog:
1
= Path for tracing with location of the current topic (breadcrumbs navigation)
2 = Cross-reference to corresponding topic in manual control
2. To find the corresponding function in manual control, select the cross-reference.
In the description of the manual control, you find additional information on the
parameter. You can follow the link in the breadcrumbs navigation area (2) and find
out to which dialog and functional block the parameter belongs.
Automating Tasks with Remote Command Scripts
To Next Page
Loading...