Rohde & Schwarz R&S SMW200A - Diagnostic Subsystem

Remote Control Commands
R&S
®
SMW200A
868User Manual 1175.6632.02 ─ 30
Return values:
<Frequency> float
Range: 0 to max
Increment: 0.001
*RST: 0
Example:
:CLOCk:INPut:FREQuency?
Usage: Query only
Options: R&S SMW-B10
Manual operation: See "Measured External Clock" on page 259
14.10 DIAGnostic Subsystem
The DIAGnostic subsystem contains the commands used for instrument diagnosis
and servicing. SCPI does not define any DIAGnostic commands; the commands lis-
ted here are all device-specific. All DIAGnostic commands are query commands
which are not affected by *RST.
The test functions are intended for services purposes.
They are thus password-protected functions. Unlock the corresponding protection level
to access them, see :SYSTem:PROTect<ch>[:STATe]
For more information, see R&S SMW Service Manual.
Common suffixes
The following common suffixes are used in remote commands:
Suffix Value range Description
DIAGnostic<hw>
[1] | 2 Signal path
DIAGnostic Subsystem