Rohde & Schwarz R&S SMW200A - HUMS Remote Control Commands

Remote Control Commands
R&S
®
SMW200A
871User Manual 1175.6632.02 ─ 30
:DIAGnostic<hw>:POINt:CATalog?
Queries the test points available in the instrument.
For more information, see R&S SMW Service Manual.
Return values:
<Catalog> string
List of comma-separated values, each representing a test point
Example: See Example "Programming example" on page 869.
Usage: Query only
:DIAGnostic<hw>[:MEASure]:POINt? <Name>
Triggers the voltage measurement at the specified test point and returns the measured
voltage.
For more information, see R&S SMW Service Manual.
Query parameters:
<Name> <test point identifier>
Test point name, as queried with the command :
DIAGnostic<hw>:POINt:CATalog?
Return values:
<Value> <value><unit>
Example: See Example "Programming example" on page 869.
Usage: Query only
14.11 HUMS Remote Control Commands
The remote control commands for the health and utilizations monitoring system
(HUMS) comprise commands of the DIAGnostic subsystem.
For all HUMS-related remote control commands, refer to the R&S
®
HUMS Health and
Utilization Monitoring Service User Manual available at:
https://www.rohde-schwarz.com/manual/HUMS
Commands
DIAGnostic:HUMS:DELete:ALL....................................................................................... 872
DIAGnostic:HUMS:DEVice:HISTory?................................................................................872
DIAGnostic:HUMS:DEVice:HISTory:DELete:ALL............................................................... 873
DIAGnostic:HUMS:FORMat............................................................................................ 873
DIAGnostic:HUMS:SAVE................................................................................................ 873
DIAGnostic:HUMS:STATe............................................................................................... 873
HUMS Remote Control Commands