Rohde & Schwarz R&S SMW200A - Page 876

Remote Control Commands
R&S
®
SMW200A
876User Manual 1175.6632.02 ─ 30
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 1)
Example: See Example "Activating screen saver mode and display
update" on page 874
Manual operation: See "Annotation Amplitude" on page 758
:DISPlay:ANNotation:FREQuency <State>
Indicates asterisks instead of the frequency values in the status bar.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 1)
Example: See Example "Activating screen saver mode and display
update" on page 874
Manual operation: See "Annotation Frequency" on page 758
:DISPlay:ANNotation[:ALL] <State>
Displays asterisks instead of the level and frequency values in the status bar of the
instrument.
We recommend that you use this mode if you operate the instrument in remote control.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Activating screen saver mode and display
update" on page 874
:DISPlay:DIALog:ID?
Returns the dialog identifiers of the open dialogs in a string separated by blanks.
Return values:
<DialogIdList> <DialogID#1>< ><DialogID#2>< > ... < ><DialogID#n>
Dialog identifiers are string without blanks. Blanks are represen-
ted as $$.
Dialog identifiers <DialogID> are composed of two main parts:
<DialogName>[<OptionalParts>]
<DialogName>
Meaningful information, mandatory input parameter for the com-
mands:
:DISPlay:DIALog:OPEN on page 877
:DISPlay:DIALog:CLOSe on page 877
DISPlay Subsystem