Remote Control Commands
R&S
®
SMW200A
889User Manual 1175.6632.02 ─ 30
The local state is set with the INIT command. Switching off the local state enhances
the measurement performance. Measurements results can be retrieved in local state
on or off.
Sensor parameters are set with the SENSe commands.
To start the measurement and retrieve the result, use the :READ<ch>[:POWer]?
command.
Suffix Value range Description
SENSe<ch>
[1] to 4 Indicates the sensor
Sensor mapping:
●
SENSe[1] - default mapping for sensors connected to the
[SENSOR] connector
●
SENSe2 - sensor connected to a [USB] connector
●
SENSe3|4 - further connected sensors to [USB] connectors,
in the connection order
Use the :SLISt commands to change the sensor mapping
READ<ch>
[1] to 4 Sensor assignment
INIate<hw>
[1] to 4 Sensor assignment
ELEMent<ch>
[1] to 25 Sensor mapping list
SENSe, READ, INITiate and SLISt Subsystems
To Next Page
Loading...