Rohde & Schwarz R&S SMW200A - Page 891

Remote Control Commands
R&S
®
SMW200A
891User Manual 1175.6632.02 ─ 30
Example: Performing a power measurement with a fixed filter
Prerequisite: The sensor is connected to the instrument and mapped to the first sensor
channel.
SENSe1:SOURce RF
//Sensor measures the power of the RF signal
:SENSe1:FILTer:TYPE NSRatio
//Selects fixed noise filter mode
:SENSe1:FILTer:NSRatio 0.02 DB
//Sets the maximum noise component in the result to 0.02 DB
:SENSe1:FILTer:NSRatio:MTIMe 10
//Limits the settling time to 10 seconds.
:SENSe1:APERture:DEFault:STATe 0
// Deactivates the default aperture time of the sensor
:SENSe1:APERture:TIMe 10e-6
// Sets the aperture time to 10 us
:SENSe1:UNIT DBM
//Selects unit dBm for the measured value
:INITiate:CONTinuous ON
//Switches the continous power measurement on
:READ?
//Triggers the measurement and displays the results
:SLISt[:LIST]?................................................................................................................ 892
:SLISt:SCAN[:STATe]......................................................................................................892
:SLISt:SCAN:LSENsor....................................................................................................892
:SLISt:SCAN:USENsor................................................................................................... 893
:SLISt:CLEar:LAN.......................................................................................................... 893
:SLISt:CLEar:USB..........................................................................................................893
:SLISt:CLEar[:ALL].........................................................................................................894
:SLISt:ELEMent<ch>:MAPPing........................................................................................894
:SLISt:SENSor:MAP.......................................................................................................894
:INITiate<hw>[:POWer]:CONTinuous............................................................................... 894
:READ<ch>[:POWer]?....................................................................................................895
:SENSe<ch>:UNIT[:POWer]............................................................................................895
:SENSe<ch>[:POWer]:APERture:DEFault:STATe.............................................................. 896
:SENSe<ch>[:POWer]:APERture:TIMe.............................................................................896
:SENSe<ch>[:POWer]:CORRection:SPDevice:SELect.......................................................896
:SENSe<ch>[:POWer]:CORRection:SPDevice:STATe........................................................897
:SENSe<ch>[:POWer]:CORRection:SPDevice:LIST?.........................................................897
:SENSe<ch>[:POWer]:DISPlay:PERManent:PRIority.........................................................897
:SENSe<ch>[:POWer]:DISPlay:PERManent:STATe........................................................... 897
SENSe, READ, INITiate and SLISt Subsystems