Rohde & Schwarz R&S SMW200A - Page 892

Remote Control Commands
R&S
®
SMW200A
892User Manual 1175.6632.02 ─ 30
:SENSe<ch>[:POWer]:FILTer:LENGth:AUTO?.................................................................. 898
:SENSe<ch>[:POWer]:FILTer:LENGth[:USER].................................................................. 898
:SENSe<ch>[:POWer]:FILTer:NSRatio............................................................................. 899
:SENSe<ch>[:POWer]:FILTer:NSRatio:MTIMe.................................................................. 899
:SENSe<ch>[:POWer]:FILTer:SONCe.............................................................................. 899
:SENSe<ch>[:POWer]:FILTer:TYPE................................................................................. 900
:SENSe<ch>[:POWer]:FREQuency..................................................................................900
:SENSe<ch>[:POWer]:LOGGing:STATe............................................................................901
:SENSe<ch>[:POWer]:OFFSet........................................................................................901
:SENSe<ch>[:POWer]:OFFSet:STATe..............................................................................901
:SENSe<ch>[:POWer]:SNUMber?................................................................................... 901
:SENSe<ch>[:POWer]:SOURce.......................................................................................902
:SENSe<ch>[:POWer]:STATus[:DEVice]?.........................................................................902
:SENSe<ch>[:POWer]:SVERsion?...................................................................................902
:SENSe<ch>[:POWer]:TYPE?.........................................................................................903
:SENSe<ch>[:POWer]:ZERO.......................................................................................... 903
:SLISt[:LIST]?
Returns a list of all detected sensors in a comma-separated string.
Return values:
<SensorList> String of comma-separated entries
Each entry contains information on the sensor type, serial num-
ber and interface.
The order of the entries does not correspond to the order the
sensors are displayed in the "NRP Sensor Mapping" dialog.
Example: See Example "Detecting and assigning a power sensor"
on page 890.
Usage: Query only
Manual operation: See "Sensor Mapping List" on page 584
:SLISt:SCAN[:STATe] <State>
Starts the search for R&S NRP power sensors, connected in the LAN or via the
USBTMC protocol.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Detecting and assigning a power sensor"
on page 890.
Manual operation: See "Scan" on page 585
:SLISt:SCAN:LSENsor <IP>
Scans for R&S NRP power sensors connected in the LAN.
SENSe, READ, INITiate and SLISt Subsystems