Rohde & Schwarz R&S SMW200A - Page 924

Remote Control Commands
R&S
®
SMW200A
924User Manual 1175.6632.02 ─ 30
:SCONfiguration:EXTernal:RF<ch>:REMote:SEND............................................................934
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:SEND...................................................934
:SCONfiguration:EXTernal:IQOutput<ch>:CONNections:CHECk?....................................... 934
:SCONfiguration:EXTernal:DISPlay <DisplayMode>
Filters the displayed connectors upon the selected criteria.
Parameters:
<DisplayMode> ALL | MAPPed | INPut | OUTPut
*RST: MAPPed
Example: See Example "Connecting and configuring external instrument"
on page 905.
Manual operation: See "Display" on page 137
:SCONfiguration:EXTernal:ACONnect
<State>
Enables automatic detection and connection setup of connected external instruments.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Distributing the I/Q streams to the output connec-
tors" on page 904.
Manual operation: See "Auto Connect" on page 137
:SCONfiguration:EXTernal:REMote:CONNect[:ALL]
:SCONfiguration:EXTernal:REMote:DISConnect[:ALL]
Triggers the instrument to establish the connections to all configured external RF and
I/Q instruments or to disconnect all existing connections.
Example:
See Example "Connecting and configuring external instrument"
on page 905.
Usage: Event
Manual operation: See "Connect/Disconnect All Remote" on page 137
:SCONfiguration:EXTernal:PBEHaviour <State>
If enabled, the connection to the external instruments is retained after preset (*RST) of
the instrument.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
SCONfiguration Subsystem