Rohde & Schwarz R&S SMW200A - Page 929

Remote Control Commands
R&S
®
SMW200A
929User Manual 1175.6632.02 ─ 30
Example:
SOURce1:POWer:LEVel:IMMediate:AMPLitude -30
SCONfiguration:EXTernal:IQOutput1:RF:COUPling ON
SCONfiguration:EXTernal:IQOutput1:RF:POWer:OFFSet -20
// RF level of the external instrument is -50 dB
// Where both the RF level and the level offset
// are applied at the external instrument
Manual operation: See "(Delta) RF Frequency/ RF Level" on page 142
:SCONfiguration:EXTernal:FADer<ch>:RF:STATe <RemConnState>
:SCONfiguration:EXTernal:BBMM<ch>:RF:STATe <RemConnState>
:SCONfiguration:EXTernal:RF<ch>:RF:STATe <RemConnState>
:SCONfiguration:EXTernal:IQOutput<ch>:RF:STATe <RemConnState>
Queries/sets the RF output state of the connected external instrument.
Parameters:
<RemConnState> 0 | 1 | OFF | ON
Example:
SCONfiguration:EXTernal:IQOutput1:RF:COUPling ON
OUTput1:STATe ON
SCONfiguration:EXTernal:IQOutput1:RF:STATe?
// 1
Example:
SCONfiguration:EXTernal:BBMM1:RF:COUPling OFF
SCONfiguration:EXTernal:BBMM1:RF:STATe ON
Manual operation: See "RF State" on page 143
:SCONfiguration:EXTernal:REMote:SCAN
Scans the network for connected instruments.
Example:
See Example "Connecting and configuring external instrument"
on page 905.
Usage: Event
Manual operation: See "Detect/Scan" on page 145
:SCONfiguration:EXTernal:REMote:SCAN:STATe?
Queries if scanning is performed or not.
To start the scanning process, use the command :SCONfiguration:EXTernal:
REMote:SCAN on page 929.
Return values:
<ScanState> 0 | 1 | OFF | ON
1
Scanning process running
0
Not scanning
SCONfiguration Subsystem