Rohde & Schwarz R&S SMW200A - Page 942

Remote Control Commands
R&S
®
SMW200A
942User Manual 1175.6632.02 ─ 30
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:RANGe:
LOWer?
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:RANGe:UPPer?
Queries the min and max frequency and PEP values that define the calibrated range.
Return values:
<PEPmax> float
Increment: 0.01
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "Frequency Range/PEP Range" on page 657
:SCONfiguration:RFALignment:SETup:INFO:CALibration:FREQuency:STEP?
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:STEP?
Queries the frequency/PEP step size with that the calibration values are selected from
the defined value range.
Return values:
<PEPstep> float
Increment: 0.01
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "Frequency Step/PEP Step" on page 658
:SCONfiguration:RFALignment:SETup:INFO:CALibration:LOCoupling?
Queries whether the instruments use a common local oscillator (LO) signal or not.
Return values:
<State> ACTive | NACTive
ACTive
All instruments are connected to the same LO reference fre-
quency.
NACTive
Each instrument uses its own local oscillator.
*RST: n.a. (factory preset)
Example: See Example "Retrieving details on the calibrated values"
on page 935.
Usage: Query only
Manual operation: See "LO Coupling" on page 658
SCONfiguration Subsystem