Rohde & Schwarz R&S SMW200A - Page 946

Remote Control Commands
R&S
®
SMW200A
946User Manual 1175.6632.02 ─ 30
SOURce1:INPut:USER2:DIRection OUTP
OUTPut1:USER2:SIGNal MARKA2
SOURce1:INPut:USER6:DIRection OUTP
OUTPut1:USER6:SIGNal MTR
OUTPut1:USER6:TRIGger:IMMediate
SOURce1:INPut:USER5:DIRection OUTP
OUTPut1:USER5:SIGNal MTR
OUTPut1:USER5:TRIGger:IMMediate
[:SOURce<hw>]:INPut:TM<ch>:DIRection........................................................................946
:OUTPut<hw>:TM<ch>:DIRection....................................................................................946
[:SOURce]:INPut:USER<ch>:DIRection............................................................................947
:OUTPut:USER<ch>:DIRection....................................................................................... 947
[:SOURce<hw>]:INPut:TM<ch>:SIGNal............................................................................947
:OUTPut<hw>:TM<ch>:SIGNal........................................................................................948
[:SOURce]:INPut:USER<ch>:SIGNal............................................................................... 949
:OUTPut:USER<ch>:SIGNal........................................................................................... 950
:OUTPut:USER<ch>:TRIGger[:IMMediate]....................................................................... 951
[:SOURce]:INPut:USER:CLOCk:LEVel.............................................................................951
[:SOURce]:INPut:USER:TRIGger:LEVel........................................................................... 951
[:SOURce]:INPut:USER:PULM:LEVel...............................................................................951
[:SOURce]:INPut:USER:CLOCk:IMPedance..................................................................... 952
[:SOURce]:INPut:USER:TRIGger:IMPedance................................................................... 952
[:SOURce]:INPut:USER:CLOCk:SLOPe...........................................................................952
[:SOURce]:INPut:USER:TRIGger:SLOPe......................................................................... 952
[:SOURce<hw>]:INPut:TM:CLOCk:LEVel......................................................................... 952
[:SOURce<hw>]:INPut:TM:TRIGger:LEVel........................................................................952
[:SOURce<hw>]:INPut:TM:CLOCk:IMPedance................................................................. 953
[:SOURce<hw>]:INPut:TM:TRIGger:IMPedance................................................................953
[:SOURce<hw>]:INPut:TM:CLOCk:SLOPe....................................................................... 953
[:SOURce<hw>]:INPut:TM:TRIGger:SLOPe......................................................................954
[:SOURce<hw>]:INPut:TM<ch>:DIRection <Direction>
:OUTPut<hw>:TM<ch>:DIRection <Direction>
Determines whether the connector is used as an input or an output.
Suffix:
OUTPut<hw> |
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
OUTPut1|SOURce1 = Baseband A/C and
OUTPut2|SOURce2 = Baseband B/D
SOURce Subsystem