Rohde & Schwarz R&S SMW200A - Page 947

Remote Control Commands
R&S
®
SMW200A
947User Manual 1175.6632.02 ─ 30
TM<ch> 1|2|3
Determines the local connector, where:
Option: R&S SMW-B10
OUTPut1:TM1|2|3 and SOURce1:INPut:TM1|2|3 define
TMC1/2/3 of Baseband A/C and
OUTPut2:TM1|2|3 and SOURce2:INPut:TM1|2|3 define
TMC4/5/6 of Baseband B/D
Option: R&S SMW-B9
OUTPut1:TM1|2 and SOURce1:INPut:TM2 = TMC1/2 of
Baseband A/C and
OUTPut2:TM1|2 and SOURce2:INPut:TM2 = TMC3/4 of
Baseband B/D
Parameters:
<Direction> INPut | OUTPut
*RST: OUTPut
Manual operation: See "T/M/(C) Connector Direction" on page 729
[:SOURce]:INPut:USER<ch>:DIRection <Direction>
:OUTPut:USER<ch>:DIRection <Direction>
Determines whether the connector is used as an input or an output.
Suffix:
USER<ch>
.
1 to 6
Parameters:
<Direction> INPut | OUTPut | UNUSed
UNUSed = the connector is not defined
Example: See Example "Global connectors settings configuration"
on page 945.
Manual operation: See "User 1 to 6 Connector Direction" on page 725
[:SOURce<hw>]:INPut:TM<ch>:SIGNal <Signal>
Determines the control signal that is input at the selected connector.
To define the connector direction, use the command [:SOURce<hw>]:INPut:
TM<ch>:DIRection.
Suffix:
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
SOURce1 = Baseband A/C and
SOURce2 = Baseband B/D
SOURce Subsystem