Remote Control Commands
R&S
®
SMW200A
954User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:INPut:TM:TRIGger:SLOPe <Slope>
Sets the polarity of the active slope of an externally applied trigger signal.
Suffix:
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
SOURce1 = Baseband A/C and
SOURce2 = Baseband B/D
Parameters:
<Slope> NEGative | POSitive
*RST: POSitive
Manual operation: See " Trigger Input Slope" on page 731
14.19.2
SOURce:BBIN Subsystem
The SOURce:BBIN subsystem contains the commands for setting the external digital
baseband signal.
In Standard mode, the external baseband signal A can be routed to path A, path B, or
both paths. The external baseband signal B can be routed to path B only.
Suffixes in the keywords ENTity<ch> and SOURce<hw>
You can address multiple entities configurations by using the SCPI commands starting
with the keyword SOURce or the alias commands starting with the keyword ENTity.
Table 14-2: Value ranges of the suffixes ENTity<ch> and SOURce<hw> in advanced configuration
with multiple entities
SCPI Syntax
ENTity<ch> SOURce<hw>
SOURce<hw>:BBIN:...
- 1 to 4
ENTity<ch>:SOURce<hw>:BBIN:...
1 to 4 1 to 4
See also Chapter 14.3, "SCPI Command Aliases for Advanced Mode with Multiple
Entities", on page 842.
Suffix Value range Description
CHANnel<ch0>
0 to 7 Channel number
Up to 8 channels per HS DIG I/Q interface and max. 8
channels for both interfaces.
Required options
See "Required Options" on page 158
See also Chapter 4.3.4, "Supported Digital Interfaces Depending on the System Con-
figuration", on page 119.
SOURce Subsystem
To Next Page
Loading...