Rohde & Schwarz R&S SMW200A - Page 957

Remote Control Commands
R&S
®
SMW200A
957User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BBIN:DIGital:SOURce <DigInpSource>
Defines the connector used as an external signal source.
Parameters:
<DigInpSource> CODER1 | FADER1 | FADER2 | CODER2
*RST: CODER1
Example: See Example "Applying an external digital baseband signal (DIG
I/Q)" on page 955.
Options: FADER1|FADER2 require R&S SMW-B14
Manual operation: See "Connector" on page 161
[:SOURce<hw>]:BBIN:DIGital:INTerface
<BBinDigInterfac>
Selects the input connector at that the signal is fed.
Parameters:
<BBinDigInterfac> DIGital | HSDin | DIGital | HSDin
DIN
DIG I/Q
HSDin
HS DIG I/Q
*RST: HSDin
Example: See Example "Applying an external digital baseband signal (HS
DIG I/Q)" on page 955.
Options: R&S SMW-B9
Manual operation: See "Interface" on page 168
[:SOURce<hw>]:BBIN:CDEVice?
Indicates the ID of an externally connected Rohde & Schwarz Instrument or
Rohde & Schwarz device.
Return values:
<CDevice> string
"None" - no device is connected.
Example:
SOURce:BBIN:CDEVice?
Queries the connected device ID.
Usage: Query only
Manual operation: See "Connected Device" on page 162
[:SOURce<hw>]:BBIN:CHANnel<ch0>:BB:STATe <BbinIqHsChanSta>
Activates the channel.
SOURce Subsystem