Rohde & Schwarz R&S SMW200A - Page 977

Remote Control Commands
R&S
®
SMW200A
977User Manual 1175.6632.02 ─ 30
LF1|LF2
Uses an internally generated LF signal.
EXT1|EXT2
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
INTB
Uses the internal baseband signal.
*RST:
LF1 <PM1>; LF2 <PM2>
Example: See Example "Performing phase modulation" on page 974.
Options: INTB requires R&S SMW-B9
Manual operation: See "Source" on page 543
[:SOURce<hw>]:PM:MODE <Mode>
Selects the mode for the phase modulation.
Parameters:
<Mode> HBANdwidth | HDEViation | LNOise
HBANdwidth
Sets the maximum available bandwidth.
HDEViation
Sets the maximum range for ΦM deviation.
LNOise
Selects a phase modulation mode with phase noise and spuri-
ous characteristics close to CW mode.
*RST: HBANdwidth
Example: See Example "Performing phase modulation" on page 974.
Manual operation: See "Mode" on page 546
[:SOURce<hw>]:PM:DEViation:MODE <PmDevMode>
Selects the coupling mode. The coupling mode parameter also determines the mode
for fixing the total deviation.
Parameters:
<PmDevMode> UNCoupled | TOTal | RATio
UNCoupled
Does not couple the LF signals.
The deviation values of both paths are independent.
SOURce Subsystem