Rohde & Schwarz R&S SMW200A - Page 980

Remote Control Commands
R&S
®
SMW200A
980User Manual 1175.6632.02 ─ 30
// Alternatively configure the pulse modulation settings for
// external modulation source
// Select the source, set the polarity of the external signal,
// select the impedance for the external pulse modulation input/
// for the external pulse modulation trigger input
SOURce:PULM:SOURce EXT
SOURce:PULM:POLarity NORMal
SOURce:PULM:IMPedance G1K
SOURce:PULM:TRIGger:EXTernal:IMPedance G10K
// Configure the pulse generator settings
// Set pulse period, width, and delay
SOURce:PULM:PERiod 10 us
SOURce:PULM:WIDth 8 us
SOURce:PULM:DOUBle:WIDTh 0.0000012
SOURce:PULM:DOUBle:DELay 0.0000045
// Activate the signal output
SOURce:PGENerator:OUTPut:STATe 1
SOURce:PULM:STATe 1
OUTPut1:STATe 1
The following commands are available:
[:SOURce<hw>]:PULM:MODE........................................................................................ 980
[:SOURce<hw>]:PULM:TRIGger:MODE...........................................................................981
[:SOURce<hw>]:PULM:PERiod....................................................................................... 981
[:SOURce<hw>]:PULM:WIDTh........................................................................................981
[:SOURce<hw>]:PULM:DELay........................................................................................ 981
[:SOURce<hw>]:PULM:DOUBle:DELay............................................................................982
[:SOURce<hw>]:PULM:DOUBle:WIDTh........................................................................... 982
[:SOURce<hw>]:PULM:DOUBle:STATe............................................................................ 982
[:SOURce<hw>]:PULM:STATe.........................................................................................982
[:SOURce<hw>]:PULM:SOURce..................................................................................... 983
[:SOURce<hw>]:PULM:TTYPe........................................................................................983
[:SOURce<hw>]:PULM:OUTPut:VIDeo:POLarity...............................................................983
[:SOURce<hw>]:PULM:POLarity..................................................................................... 984
[:SOURce<hw>]:PULM:IMPedance..................................................................................984
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance...................................................... 984
[:SOURce<hw>]:PULM:MODE <Mode>
Selects the mode for the pulse modulation.
Parameters:
<Mode> SINGle | DOUBle
SINGle
Generates a single pulse.
DOUBle
Generates two pulses within one pulse period.
*RST: SINGle
SOURce Subsystem