Rohde & Schwarz R&S SMW200A - Page 987

Remote Control Commands
R&S
®
SMW200A
987User Manual 1175.6632.02 ─ 30
Parameters:
<PGain> float
Range: -50 to 50
Increment: 1E-3
*RST: 0
Default unit: dB
Example:
BBIN:PGA 3dB
Sets the relative gain of 3 dB for the external baseband signal.
Manual operation: See " Gain" on page 413
[:SOURce<hw>]:BB:ROUTe <Route>
[:SOURce<hw>]:BBIN:ROUTe <Route>
Selects the signal route for the internal/external baseband signal.
The internal and external signals are summed, if necessary.
Parameters:
<Route> A | B | AB
Example:
SOURce1:BBIN:ROUTe A
// the external baseband signal is added to path A
Options: R&S SMW-B10
Manual operation: See " Signal Routing" on page 158
[:SOURce<hw>]:BB:CODer:MODE <Mode>
Defines the source of the baseband generator.
Parameters:
<Mode> CODer | BBIN
CODer
Internal baseband generator
BBIN
An external digital baseband signal provided at the digital inter-
face
*RST: CODer
Example:
SOURce1:BB:CODer:MODE BBIN
[:SOURce<hw>]:BB:POWer:PEAK?
Queries the peak level of the baseband signal relative to full scale of 0.5 V (in terms of
dB full scale).
SOURce Subsystem