Rohde & Schwarz R&S SMW200A - Page 988

Remote Control Commands
R&S
®
SMW200A
988User Manual 1175.6632.02 ─ 30
Return values:
<Peak> float
Range: -145 to 30
Increment: 0.01
*RST: 0
Default unit: dBfs
Example:
BB:POW:PEAK
Queries the peak level of the baseband signal.
Usage: Query only
[:SOURce<hw>]:BB:CFACtor?
Queries the crest factor of the baseband signal.
Return values:
<CFactor> float
Range: 0 to 100
Increment: 0.01
*RST: 0
Default unit: dB
Example:
SOURce1:BB:CFACtor?
Queries the crest factor of the baseband signal.
Usage: Query only
[:SOURce<hw>]:BB:POWer:RMS?
Queries the RMS level of the baseband signal relative to full scale of 0.5V (in terms of
dB full scale).
Return values:
<Rms> float
Range: -145 to 30
Increment: 0.01
*RST: 0
Default unit: dBfs
Example:
BB:POW:RMS?
Queries the rms level of the baseband signal.
Usage: Query only
14.19.4.2 SOURce:BB:DM Subsystem
This section list the commands of the SOURce:BB:DM subsystem. The commands are
divided into sections, where the last one describes how to use lists for digital modula-
tion in remote control, and all other sections describe the configuration of the digital
modulation.
SOURce Subsystem