Rohde & Schwarz R&S ZNA Series - Page 1001

Command reference
R&S
®
ZNA
1001User Manual 1178.6462.02 ─ 29
CALCulate<Chn>:EYE:MASK:CENTer:VERTical <VerticalOffset>
Defines the vertical center of the eye mask in the related eye diagram.
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<VerticalOffset> Vertical offset relative to the 0 V level, i.e. the Voltage level of
the center.
Default unit: V
Options: R&S ZNA-K20
Manual operation: See "Mask Center" on page 824
CALCulate<Chn>:EYE:MASK:DATA?
Returns the detailed results of the mask test in the related eye diagram (i.e. the con-
tents of the corresponding result info field).
This command will raise an execution error if the active trace in the selected channel is
not an eye diagram, or if CALCulate<Chn>:EYE:MASK:STATe is OFF.
Use MMEMory:STORe:EYE:MASK:RESults to save these results to an ASCII file.
Suffix:
<Chn>
.
Channel number used to identify the active trace
SCPI command reference