Rohde & Schwarz R&S ZNA Series - Page 1228

Command reference
R&S
®
ZNA
1228User Manual 1178.6462.02 ─ 29
Parameters:
<Command> 3 to 37 hexadecimal digits (0-F), defining the command to be
executed: digit 1 is the slave address, digits 2 and 3 specify the
command number and the remaining digits represent the data
part (up to 17 digit pairs).
Manual operation: See "RFFE columns (sweep sequencer table)" on page 666
CONTrol:VSE:ADDRess <Adress>
Sets/gets the VISA address of a remote R&S VSE instance.
Parameters:
<Adress> VISA resource string
Manual operation: See "VISA address list" on page 701
CONTrol:VSE:CONFig:LOAD
<FilePathOnVna>
If a connection to a R&S VSE instance is established, you can load its configuration
from a file on the R&S ZNA (previously created using Save VSE Configuration).
Setting parameters:
<FilePathOnVna> A file path on the R&S ZNA, either absolute or relative to the
current directory (see MMEMory:CDIRectory)
Usage: Setting only
Manual operation: See "Load VSE Configuration" on page 702
CONTrol:VSE:CONFig:SAVE <FilePathOnVna>
If a connection to a R&S VSE instance is established, you can download its current
configuration and save it to a file on the R&S ZNA.
Setting parameters:
<FilePathOnVna> A file path on the R&S ZNA, either absolute or relative to the
current directory (see MMEMory:CDIRectory)
Usage: Setting only
Manual operation: See "Save VSE Configuration" on page 702
CONTrol:VSE:CONNect
If CONTrol:VSE:LOCal on page 1229 is set to 1, the setting tries to connect to a local
R&S VSE. Otherwise it tries to connect to a remote R&S VSE, whose VISA address
was previously specified using CONTrol:VSE:ADDRess.
The query returns the connection state: 1 = connected to a R&S VSE, 0 = not connec-
ted .
Manual operation:
See "Start/Connect VSE / Disconnect VSE" on page 701
SCPI command reference