Rohde & Schwarz R&S ZNA Series - Page 1533

Command reference
R&S
®
ZNA
1533User Manual 1178.6462.02 ─ 29
SOURce<Ch>:RLO:PABSolut <Mode>
Allows you to define the output power mode at the (optional) rear LO Out port for chan-
nel <Ch>.
Suffix:
<Ch>
.
Channel number
Parameters:
<Mode> OFF (0)
Use the channel base power P
b
ON (1)
Use a fixed value of 0 dBm
Options: R&S ZNA-B8
Manual operation: See "Channel Base Power" on page 630
SOURce<Ch>:RLO:PERMenable
<Boolean>
Defines whether the source power at the (optional) rear LO Out port is permanently on
in channel <Ch> ("generator port") .
Suffix:
<Ch>
.
Chanel number
Parameters:
<Boolean> OFF (0)
Power is only on for partial measurements that require the port
as a drive port.
ON (1)
Power is permanently on
*RST: OFF
Options: R&S ZNA-B8
Manual operation: See "Source Gen" on page 671
SOURce<Ch>:RLO:POFFset <Value>
Defines the power offset of the the (optional) rear LO Out port for channel <Ch>.
If SOURce<Ch>:RLO:PABSolut on page 1533 is OFF, then the output power is equal
to the channel base power f
b
plus the power offset. Otherwise the output power is set
to the fixed power offset.
Suffix:
<Ch>
.
Channel number
Parameters:
<Value> Offset value in dB
Options: R&S ZNA-B8
SCPI command reference