Rohde & Schwarz R&S ZNA Series - Page 1600

Command reference
R&S
®
ZNA
1600User Manual 1178.6462.02 ─ 29
<LogPt> Logical port number used to number balanced ports.
Range according to the current port configuration
(SOURce<Ch>:LPORt<LogPt>). If an undefined balanced port
number is used, the analyzer generates an error message.
Exception: Parameter ALL, see below.
Setting parameters:
<Scope> ALL
If ALL is specified, all logical ports are dissolved; the <log_port>
suffix is ignored. If ALL is omitted, only the specified balanced
port is dissolved.
Example: See SOURce<Ch>:LPORt<LogPt>
Usage: Setting only
Manual operation: See "Select Predefined Port" on page 353
SOURce<Ch>:NFIGure:CALibration:TPOWer <SourcePowNfigCalExtAtt>
Suffix:
<Ch>
.
Parameters:
<SourcePowNfigCalExtAtt>Default unit: dBm
Options: R&S ZNA-K30
Manual operation: See "Src Power Thru Meas" on page 595
SOURce<Ch>:NFIGure:CALibration:TPOWer:STATe <Boolean>
Suffix:
<Ch>
.
Parameters:
<Boolean>
Options: R&S ZNA-K30
Manual operation: See "Src Power Thru Meas" on page 595
SOURce<Ch>:PATH<Pt>:DIRectaccess <Path>
Same functionality as [SENSe<Ch>:]PATH<Pt>:DIRectaccess.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Parameters:
<Path> NONE | B16 | REV | SRC
Direct access signal path
SCPI command reference