Rohde & Schwarz R&S ZNA Series - Page 1840

Index
R&S
®
ZNA
1840User Manual 1178.6462.02 ─ 29
GPIO interface configuration
R&S ZN-B15/-Z15 Var. 03 .........................................656
GPIO voltage and current measurements .......................663
Range ....................................................................... 664
Results ...................................................................... 665
Shunt ........................................................................ 664
Start Meas ................................................................ 664
Graphic zoom .................................................................... 66
Ground connector ............................................................. 41
Group Delay .................................................................... 424
Aperture Points ......................................................... 424
GTL ............................................................................... 1783
H
H/L SWITCH
Diplexer .......................................................................90
H/L Switch cable ............................................................... 98
Handler I/O
External .......................................................................41
Handshake bus ............................................................. 1782
Hardkey panel ................................................................... 53
Hardware .........................................................................877
Hardware (connectors) ..................................................1779
Hardware info .................................................................. 877
Harmonic grid .................................................................. 250
Automatic .................................................................. 452
Set and keep .............................................................451
Hide All Data ................................................................... 441
Hide All Mem ................................................................... 441
Hide All Other Traces ...................................................... 433
Hide Sensitive Information .............................................. 846
HiSLIP ............................................................................. 931
Horiz. Line ....................................................................... 497
Response Value ........................................................ 498
Show Horiz. Line ....................................................... 498
I
Ideal (cal kit) .................................................................... 202
IEC/IEEE Bus Interface ................................................. 1782
IECWIN32 ....................................................................... 933
IEEE 370 ......................................................................... 298
IEEE 488 CH 1 .............................................................. 1782
IEEE 488 CH 2 .............................................................. 1782
IEEE 488 Interface ............................................................ 41
IF Gain Mode
Low Dist .................................................................... 689
Low Noise ................................................................. 689
IFC ...................................................................... 1782, 1783
Imag ................................................................................ 423
Image Suppr.
Auto .......................................................................... 687
LO < RF .................................................................... 687
LO > RF .................................................................... 687
Imbalance Differential dialog ........................................... 350
Imbalance parameters .................................................... 165
Impedance ...................................................................... 154
Import
Cal Kit ....................................................................... 589
Sweep segments ...................................................... 555
Import Complex Data dialog ............................................468
Import Data to New Mem .......................................... 469
Import Data to New Mem ................................................ 469
Impulse Response .......................................................... 449
In-situ De-Embedding ..................................................... 299
Increased IF bandwidth 30 MHz (R&S ZNA-K17) ........... 288
Increased measurement bandwidth 30
MHz (R&S ZNA-K17)
...................................................................................... 1324
Independent Generator Settings dialog .......................... 920
INFintiy ............................................................................ 943
Info dialog ........................................................................874
Cal Validation tab ...................................................... 879
Hardware tab ............................................................ 877
Lost Trigger tab ......................................................... 879
Options tab ............................................................... 876
Selftest tab ................................................................ 878
Setup tab .................................................................. 875
Info Table .........................................................................846
Inline calibration .....................................................211, 1754
Instrument calibration ........................................................ 73
Instrument hardware ....................................................... 949
Instrument Messages ............................................ 890, 1784
Instrument security procedures ......................................... 22
Instrument tour .................................................................. 34
Instrument-control commands .........................................939
Interface
functions (GPIB bus) ............................................... 1783
Interface Clear ...............................................................1782
Interface message ...........................................................939
Interface messages
GPIB ....................................................................... 1783
VXI-11 ..................................................................... 1781
Interfaces ...................................................................... 1779
Intermodulation measurements .......................................380
R&S ZNA-K14 ........................................................... 262
Results ...................................................................... 267
Intermodulation tab ......................................................... 380
Internal 3rd and 4th source ............................................. 302
Internal combiner P1-P2 (2-port R&S ZNA) .................... 311
Internal combiner P1-P3 (4-port R&S ZNA) .................... 311
Internal pulse modulators ................................................ 309
Internal reference ............................................................ 886
Internal second LO generator ......................................... 303
Internal second source (for 2-port R&S ZNA) ................. 303
Inv Smith ......................................................................... 423
Inverted Smith chart ........................................................ 146
IP Address .......................................................................888
IP address setting ......................................................... 1775
ISD
Advanced settings .................................................... 736
IST flag .................................................................... 953, 959
K
Keyboard ........................................................................... 33
Keyword (SCPI command) ..............................................939
Kit Standards dialog ........................................................ 617
Add standard ............................................................ 619
Copy... standard ........................................................ 619
Delete standard ........................................................ 619
One Port Standards .................................................. 618
Read .s1p File... ........................................................619
Read .s2p File... ........................................................619
Two Port Standards .................................................. 618
View / Modify... standard ........................................... 619
Known devices
external generators ........................................... 898, 923
external power meters .............................................. 892
External switch matrices ........................................... 911
L
Labels on casing ............................................................... 80