GUI reference
R&S
®
ZNA
373User Manual 1178.6462.02 ─ 29
Figure 5-4: NF setup: Cal & Meas Overview dialog
With all relevant settings displayed on one page, you can check if NF calibration and
measurement are set up properly without browsing through various dialogs.
Quickset
Opens the NF quickset dialog that guides you through to setup of a noise figure (NF)
measurement.
If external switch matrices are used, the NF quickset functionality is not available and
hence this button is disabled.
Advanced Settings
Opens the "Advanced NF Settings" dialog, which allows to perform expert settings for
NF calibration and measurement.
Meas softtool
To Next Page
Loading...
