GUI reference
R&S
®
ZNA
592User Manual 1178.6462.02 ─ 29
Delay Calibration Mixer Settings
The controls in this section are only active, if the current channel is set up for mixer
delay measurements (Chapter 5.2.15, "Two Tone Group Dly tab (frequency-converting
DUT)", on page 416). They allow you to configure the properties of a mixer delay cali-
bration.
Use Constant Cal Delay ← Delay Calibration Mixer Settings
If checked, you can specify a Constant Cal Delay. Otherwise you can use the Variable
Cal Delay File button to pick a CSV file with delay data for the reference mixer.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CDMode
Constant Cal Delay ← Delay Calibration Mixer Settings
If Use Constant Cal Delay is checked, you can enter a constant calibration delay.
Remote command:
[SENSe<Ch>:]FREQuency:MDELay:CDELay
Variable Cal Delay File ← Delay Calibration Mixer Settings
This button is only enabled, if Use Constant Cal Delay is unchecked. It allows you to
load delay data for the reference mixer from a CSV file.
Remote command:
MMEMory:LOAD:MDAData
Cal. Power Settings tab
The "Cal Power Setting" tab collects all calibration-related power settlings that were
previously distributed across several softtool tabs and dialogs.
Cal softtool
To Next Page
Loading...
