GUI reference
R&S
®
ZNA
612User Manual 1178.6462.02 ─ 29
CALCulate:CALValidate:RESPonse:REAL:UPPer
CALCulate:CALValidate:RESPonse:IMAGinary:LOWer
CALCulate:CALValidate:RESPonse:IMAGinary:UPPer
CALCulate:CALValidate:RESPonse:PRESet
Preferences
Allows you to configure the behavior of the validation diagrams and traces.
Unchecking "Auto Scale" prevents the traces from scaling as the measurement and/or
standard changes. Unchecking "Average On" turns off averaging.
"Format" selects the traces to be displayed.
Remote command:
CALCulate:CALValidate:AVERage[:STATe]
CALCulate:CALValidate:FORMat
Basic Mode
Switches to Basic mode
5.11.2 Cal Devices tab
Provides access to all functions for calibration kit management and cal unit characteri-
zation.
Background information
Refer to the following sections:
●
Chapter 4.5.2, "Calibration standards and calibration kits", on page 199
●
Chapter 4.5.5.3, "Characterization of calibration units", on page 210
The buttons in the "Cal Devices" tab open the following dialogs:
●
"Cal Connector Types...": See Chapter 5.11.2.1, "Cal Connector Types dialog",
on page 613
●
"Cal Kits...": See Chapter 5.11.2.2, "Calibration Kits dialog", on page 615
●
"Characterize Cal Unit...": See Chapter 5.11.2.3, "Characterize Cal Unit dialog",
on page 621
Cal softtool
To Next Page
Loading...
