GUI reference
R&S
®
ZNA
641User Manual 1178.6462.02 ─ 29
Ch<n> Calibration Properties/Cal Group <n> Properties
Displays the basic channel settings and the properties of the system error correction
and the power correction for the channel (calibration group) selected in the "Channel
State" ("Pool") table.
"Ch<n> Calibration Properties" also indicates settings mismatches (between the
selected channel and the channel setup that was used during calibration) that lead to a
"Cal Off". Currently this indication is limited to settings related to Parallel Measure-
ments with Frequency Offset.
In addition, it is stated whether sweep data are available for the selected calibration.
Remote command:
[SENSe<Ch>:]CORRection:DATE?
[SENSe<Ch>:]CORRection:DATA:PARameter<Sfk>?
[SENSe<Ch>:]CORRection:DATA:PARameter<Sfk>:PORT<PhyPt>?
[SENSe<Ch>:]CORRection:DATA:PARameter:COUNt?
[SENSe<Chn>:]CORRection:SSTate?
5.11.4.4 JoinCal dialog
Allows you to join existing calibrations.
Access: Channel – [Cal] > "Use Cal" > "JoinCal"
Background information
See Chapter 4.5.9, "Joining calibrations", on page 227.
Cal softtool
To Next Page
Loading...
