GUI reference
R&S
®
ZNA
668User Manual 1178.6462.02 ─ 29
Balanced Ports...
Opens a dialog that allows you to enable/disable physical ports and to define logical
ports (balanced or unbalanced) in the active channel. See Chapter 5.2.2.5, "Balanced
Ports dialog", on page 352.
Note: If either multiple DUTs are configured (see Chapter 5.12.2.3, "Define Parallel
Measurement dialog", on page 682) or the "Fixture Simulator" is disabled for the rela-
ted channel (see "Fixture Simulator" on page 655), the "Balanced Ports..." button is
inactive (grayed out).
Multiple DUTs...
Opens a dialog that allows you to set up the analyzer for parallel measurements on
multiple DUTs. See Chapter 5.12.2.3, "Define Parallel Measurement dialog",
on page 682.
5.12.2.2 Port Settings dialog
The "Port Settings" dialog is an example of a Multi-channel setup dialog. For the
selected channel, it configures the source and receiver ports of the R&S ZNA for arbi-
trary frequencies, source and receiver levels.
Furthermore, it gives convenient access to the stimulus settings, and allows you to
define and configure alternative input and output paths related to R&S ZNAxx-B16 and
R&S ZNA-B26.
Access: Channel – [Channel Config] > "Port Config" > "Port Settings..."
Channel Config softtool
To Next Page
Loading...
