Rohde & Schwarz R&S ZNA Series - 5.14.7 Balanced tab

GUI reference
R&S
®
ZNA
745User Manual 1178.6462.02 ─ 29
Note: The loaded file is stored in the active recall set. Persisted recall sets contain the
full de-/embedding data so that they can be transferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:PPAir:DEEMbedding<ListId>
MMEMory:LOAD:VNETworks<Ch>:PPAir:EMBedding<ListId>
5.14.7 Balanced tab
Selects 4-port transformation networks for balanced port deembedding/embedding,
defines their parameters, assigns them to a balanced port and enables embedding.
Use the complementary dock widget to create Balanced panel and to activate or deac-
tivate dembedding/embedding for selected balanced ports (see Chapter 5.14.1.5, "Bal-
anced panel", on page 712).
Background information
Refer to the section Chapter 4.6.2.10, "Combining Several de-/embedding networks",
on page 244.
Offset Embed softtool