GUI reference
R&S
®
ZNA
753User Manual 1178.6462.02 ─ 29
Note: The loaded file is stored in the active recall set. Persisted recall sets contain the
full (de-)embedding data so that they can be transferred to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:DIFFerential:EMBedding<LogPt>
5.14.10 Config tab
The "Config" tab provides means to configure the overall "Offset Embed" calculation.
Offset > Calculate after De-/Embed.
Changes the position of the "Offset" calculation in the "Offset Embed" calculation
chain.
If unchecked (default), the offset is calculated before de-/embedding. If checked, it is
calculated after de-/embedding.
Top
= Default offset calculation
Bottom = Offset calculation after de-/embedding (GUI mockup)
Offset Embed softtool
To Next Page
Loading...
