Rohde & Schwarz R&S ZNA Series - 5.14.11 Deembed Assistant tab

GUI reference
R&S
®
ZNA
754User Manual 1178.6462.02 ─ 29
Remote command:
[SENSe:]CORRection:EDELay:VNETwork
Offset > Wave De-/Embed.
If checked, the firmware uses the new, wave-based de-/embedding calculation
(default). Otherwise, the legacy S parameter-based calculation is used. See Chap-
ter 4.1.7, "Data flow", on page 120.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:WAVes
5.14.11 Deembed Assistant tab
The "Deembed Assistant" softtool tab and the related Deembedding Assistant dock
widget panel simplify common fixture deembedding scenarios.
The deembedding assistant functionality requires at least one of the fixture deembed-
ding software options:
●
R&S ZNA-K220 (see Chapter 4.7.16, "In-situ de-embedding", on page 299)
●
R&S ZNA-K230 (see Chapter 4.7.17, "Smart fixture de-embedding", on page 300)
●
R&S ZNA-K210 (see Chapter 4.7.15, "Eazy de-embedding based on IEEE 370",
on page 298)
If none of these options are available, the "Deembed Assistant" tab is hidden.
Background information
Refer to Chapter 4.6.2.9, "Fixture modeling and deembedding", on page 242.
Offset Embed softtool