Rohde & Schwarz R&S ZNA Series - Page 756

GUI reference
R&S
®
ZNA
756User Manual 1178.6462.02 ─ 29
Remote command:
n.a.
Output Directory...
Opens a dialog that allows you to specify the directory where the fixture modeling tools
store their data.
Default is
C:\Users\Public\Documents\Rohde-Schwarz\ZNA\Embedding.
Remote command:
CALCulate:FMODel:DIRectory
CALCulate:FMODel:DIRectory:DEFault
CALCulate:FMODel:DIRectory:DEFault:CLEar
Deembedding Files...
This button is only enabled, if the coupon data provided to the deembedding tool was
at least partly loaded from file. See "Page 2: Measure / Load and Apply" on page 761.
A section "Coupon B" is only available, if you uncheck "Use Same Coupon Left and
Right" on page 760 and specify a file instead of measuring "Coupon B".
Remote command:
CALCulate:FMODel:DEASsistant:COUPon:LEFT:FILE
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:FILE
All Deembedding Activated
Deactivates or activates all deembeddings (single-ended, balanced, port set, ground
loop) for the active channel, if any.
Offset Embed softtool