Rohde & Schwarz R&S ZNA Series - Page 763

GUI reference
R&S
®
ZNA
763User Manual 1178.6462.02 ─ 29
CALCulate:FMODel:DEASsistant:COUPon:LEFT:PORT
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:PORT
CALCulate:FMODel:DEASsistant:COUPon:LEFT:MEASure
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:MEASure
CALCulate:FMODel:DEASsistant:COUPon:LEFT:FILE
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:FILE
CALCulate:FMODel:DEASsistant:COUPon:LEFT:CLEar
CALCulate:FMODel:DEASsistant:COUPon:RIGHt:CLEar
Measure / Apply section
After you have measured the coupons (or loaded their data from file), you can proceed
with the DUT. Choose:
●
A single-ended or balanced port for the 1x DUT sides
●
Two single-ended ports for the 2x single-ended DUT sides
●
A range of single-ended or balanced ports for the nx DUT sides
If you want to apply impedance correction, select "Impedance Correction" and "Mea-
sure" the DUT.
Once the coupons (and the DUT) are measured, the "Apply" button becomes active.
Use it to run the tool and, if successful, perform the deembedding on the selected
ports.
Offset Embed softtool