GUI reference
R&S
®
ZNA
768User Manual 1178.6462.02 ─ 29
5.14.12.2 Delta-L measurement
When the Delta-L measurement starts, the analyzer firmware prepares the Delta-L
measurement channel, populates the diagram area with the required measurement
traces, and opens the Delta-L Measurement dock widget.
Delta-L Measurement dock widget
The "Delta-L Measurement" dock widget is where coupon measurements are per-
formed and/or corresponding touchstone files are selected.
The Measurements setting in the "Delta-L Settings" dialog determines whether single-
ended or balanced can be measured. "No ports available!" in the dock widget and "No
Trace" in the diagram area indicates that no ports of the selected type are configured.
Access:
●
Channel – [Offset Embed] > "Delta-L" > "Delta-L Measurement"
●
Delta-L Settings dialog > "OK"
1L Measurement/2L Measurement/3L Measurement
The settings in the "1L Measurement"/"2L Measurement"/"3L Measurement" sections
configure and control the measurement of the 1st/2nd/3rd line.
The "1L Measurement" is always enabled. Depending on the selected "Method"
on page 765, the "2L Measurement" and "3L Measurement" can be disabled.
Load File ← 1L Measurement/2L Measurement/3L Measurement
Loads coupon measurement results from a s2p or s4p Touchstone file.
Remote command:
CALCulate:FMODel:DELT:M1L:FILename
CALCulate:FMODel:DELT:M2L:FILename
CALCulate:FMODel:DELT:M3L:FILename
Offset Embed softtool
To Next Page
Loading...
