Rohde & Schwarz R&S ZNB - Page 1150

Command Reference
R&S
®
ZNB/ZNBT
1150User Manual 1173.9163.02 ─ 53
Parameters:
<InputOutput> RF | LO | LO1 | LO2 | IF
RF - mixer input signal
LO | LO1 | LO2 - local oscillator signal 1 or 2 (for 2-stage mixer
measurements; see [SENSe<Ch>:]FREQuency:
CONVersion:MIXer:STAGes)
IF - mixer output signal (mixing product)
*RST: RF
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Frequency tab" on page 556
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:IFPort
<PortNumber>
Selects an analyzer port as receive port for the IF signal.
Suffix:
<Ch>
.
Channel number
Parameters:
<PortNumber> Range: 1 to number of test ports
*RST: 2
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Port selection" on page 556
[SENSe<Ch>:]FREQuency:CONVersion:MIXer:LOMultiplier<Stg> <Numerator>,
<Denominator>
Selects the frequency conversion factors for the LO signal.
The conversion factor is a ratio of two positive integers: numerator and denominator.
Suffix:
<Ch>
.
Channel number
<Stg> Mixer stage signals LO 1 or LO 2; see [SENSe<Ch>:
]FREQuency:CONVersion:MIXer:STAGes
Parameters:
<Numerator>
Range: 1, 2, 3 ...
*RST: 1
<Denominator> Range: 1, 2, 3 ...
*RST: 1
Example: See [SENSe<Ch>:]FREQuency:CONVersion:MIXer:
MFFixed
Manual operation: See "Multiplication tab" on page 557
SCPI Command Reference