Rohde & Schwarz R&S ZNB - Page 1234

Command Reference
R&S
®
ZNB/ZNBT
1234User Manual 1173.9163.02 ─ 53
*RST: RRAFter
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
Manual operation: See "Flatness Cal – Pwr Cal Method" on page 492
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:PMReadings <NoReadings>
Selects the number of power meter readings for source power calibration method
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:METHod RRAFter.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the
parameter is valid for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the parame-
ter is valid for all sources.
Parameters:
<NoReadings> Number of power meter readings. If the value exceeds the maxi-
mum number of calibration sweeps (SOURce<Ch>:
POWer<PhyPt>:CORRection:COLLect:AVERage[:COUNt])
the latter is adjusted.
Range: 1 to 100
*RST: 1
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection[:ACQuire]
.
SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:RRECeiver <arg0>
Enables or disables calibration of the reference receiver together with the source
power calibration.
Note: It is not possible to disable flatness calibration
(SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:FLATness) and the refer-
ence receiver calibration simultaneously.
Suffix:
<Ch>
.
Calibrated channel number. This parameter is ignored; the verifi-
cation is either enabled or disabled for all channels.
<PhyPt> Calibrated port number. This parameter is ignored; the verifica-
tion is either enabled or disabled for all sources.
Parameters:
<arg0> Enables (ON) or disables (OFF) reference receiver calibration.
*RST: ON
Example: See SOURce<Ch>:POWer<PhyPt>:CORRection:COLLect:
FLATness on page 1232.
SCPI Command Reference