Rohde & Schwarz R&S ZNB - Page 299

GUI Reference
R&S
®
ZNB/ZNBT
299User Manual 1173.9163.02 ─ 53
6.5.1.2 New Trace Dialog
The "Trc+" tool bar button allows you to create a trace in the active channel.
●
Tap/click the "Trc+" button to duplicate the active trace (equivalent to Add Trace).
●
Drag the respective button onto the diagram area to create the trace in any other
existing diagram or in a new one.
After the button has been dropped, the "New Trace" dialog pops up and lets you
select the quantity to be measured.
left
= buttons (up to 9 ports)
right = numeric input (10 or more ports)
6.5.1.3 Trace Manager Dialog
The "Trace Manager" dialog allows you to perform operations on traces.
Access: TRACE – [TRACE CONFIG] > "Traces" > "Trace Manager..."
All existing traces of the current recall set are listed in a table with several editable
(white) or non-editable (gray) columns.
Table Area
The table contains the following columns:
●
"Name" indicates name of the related trace.
Trace names must be unambiguous across all channels and diagram areas in a
recall set.
●
"On" indicates and controls the visibility of the related trace.
Trace Config Softtool