GUI Reference
R&S
®
ZNB/ZNBT
405User Manual 1173.9163.02 ─ 53
The analyzer uses a simple ASCII format to export sweep segment data. By default,
the sweep segment file extension is *.SegList. The file starts with two comment
lines containing the version and a third line reproducing the header of the segment list.
The following lines contain the entries of all columns of the segment list, including the
"Displayed Columns" that ae configured in the "Define Segments" dialog.
Example:
The segmented sweep range
is described by the following sweep segment file:
Note: The *.SegList file actually contains more columns listing all channel settings
of the individual sweep segments. The headings of the additional columns are IF Band-
width [Hz], en:IF Selectivity, en:IF Sideband, Meas Delay [µs], bo:Sweep Time
Auto,en:Frq Sweep Mode.
Remote command:
MMEMory:LOAD:SEGMent
MMEMory:STORe:SEGMent
Displayed Columns Dialog
The "Displayed Columns" dialog allows you to select the channel settings that can be
defined per sweep segment. These settings are displayed in the Define Segments Dia-
log and in the "Point List" (opened via Show Point List...).
Access: Define Segments Dialog > "Displayed Columns..."
All segment-specific settings can be modified in the "Define Segments" dialog. By
default, the first sweep segment is created with the channel settings defined for unseg-
mented sweep types. When any further sweep segment created, it uses the channel
settings of the previously active segment.
Related information
Refer to the following sections:
●
Chapter 6.10.2.2, "Define Segments Dialog", on page 402
●
"Show Point List..." on page 404
Sweep Softtool
To Next Page
Loading...
